configure cisco virtual wireless lan controller to layer 3

The WLC will go through some boot processes, but eventually you will see the following displayed: Keep in mind that the Command Line Interface (CLI) is IOS- like but not identical, so it can take some getting used to. Most of the process is menu-driven, so knowing the command syntax is not a hard requirement. To perform the very initial configuration on the WLC-2106, you will need to be connected to the console port of the device using a terminal services client. Step 2: Wireless LAN Controller Initial Configuration For that reason, the port to the WLC should be configured for trunking using the following commands: Wireless LAN controllers are the “brains” behind wireless networking and have the ability to create the mappings between VLANs and SSID’s. Wireless LAN Controller Port Configuration.For that reason, set the port to access mode as follows:

Lightweight AP’s send traffic to specific VLANs using tunnels created between the AP and the Wireless LAN controller rather than defining VLANs on the AP itself.

If you plan to use multiple VLANs and SSID’s, configure the AP port for trunking mode, as follows: Make certain that the VLAN exists, and it doesn’t issue the following command from global configuration mode: If you plan to only configure and use a single SSID mapped to a single VLAN, issue the following command on the attached port: Autonomous AP’sFirst decide what design you plan to use regarding single or multiple SSID’s on the AP.The ASA 5500 platform can do a few things but is not really intended for use as a routing device.Īssuming that the following is already completed, you will need to perform some specific tasks in order to support the attached wireless devices, as follows:īy default, power should be configured to automatically detect the attached device, but if it has been disabled, use the following commands to correct the issue: If not, you may need to add a router by way of a trunk connection to perform that function for you. If you happen to have a Layer 3 PoE switch (e.g., 3560, 3750), then you have a lot of extra work done at the outset since the device itself can route between VLAN segments. Most of the requirements take place on the management devices, but the underlying switch infrastructure requires some preparations as well. Configuring a wireless lab for study and testing capabilities is a bit more involved than you might think at first glance.

Configure cisco virtual wireless lan controller to layer 3